Materials
Polymaker PolyMax PLA
Impact-modified PLA for functional parts.
Verified November 2026 · Polymaker data sheetPrint settings
- Nozzle temperature
- 190–230°C
- Bed temperature
- 25–60°C
- Density
- 1.17 g/cm³
- Length per kg (1.75 mm)
- ≈ 355 m
- Enclosure
- Not needed
- Drying
- 55°C for 6 h
- Typical price
- $32 per kg
About PLA
Easiest to print, low warp, rigid. Softens around 55–60°C, so it is a poor choice for hot cars or outdoor sun.
Getting good results with Polymaker PolyMax PLA
- Start near the middle of the range (210°C) and print a temperature tower to find your printer's sweet spot.
- Faster printing needs a hotter nozzle; slow, detailed prints look best near the low end of the range.
- No enclosure needed; keep part cooling on after the first few layers.
- Dry it (55°C for 6 h) if you hear popping, see extra stringing, or the surface turns rough.
Plan a print with the print cost calculator or convert meters to grams with the filament converter. Always check the label on your spool, since makers update their recommendations.