Materials
Polymaker PolyLite PETG
General-purpose PETG with good layer adhesion.
Verified November 2026 · Polymaker data sheetPrint settings
- Nozzle temperature
- 230–240°C
- Bed temperature
- 70–80°C
- Density
- 1.25 g/cm³
- Length per kg (1.75 mm)
- ≈ 333 m
- Enclosure
- Not needed
- Drying
- 60°C for 6 h
- Typical price
- $22 per kg
About PETG
Tougher and more heat resistant than PLA, food-contact grades exist, strings more. Bonds strongly to smooth PEI.
Getting good results with Polymaker PolyLite PETG
- Start near the middle of the range (235°C) and print a temperature tower to find your printer's sweet spot.
- Faster printing needs a hotter nozzle; slow, detailed prints look best near the low end of the range.
- No enclosure needed; keep part cooling on after the first few layers.
- Dry it (60°C for 6 h) if you hear popping, see extra stringing, or the surface turns rough.
Plan a print with the print cost calculator or convert meters to grams with the filament converter. Always check the label on your spool, since makers update their recommendations.